Just trying to figure out a new to me Spra Coupe 7650 with Envizio Pro. I can't get the rate bump buttons to work. I have them activated and they are on the display however they don't respond when I touch them. I've done a touch screen calibration and everything else seems to work fine. I've set my rate adjust increment at 2 gal.
I also can't get more than about 70 psi out of the pump. I've read the manual several times and can't find anything about adjusting this. I'm running 11002 nozzles and the flow control valve is working fine.
-Doesn't seem to matter if the sparge valve is open or closed.
-The bypass valve is also closed.
-The strainers are clean.
I see there is a set screw on top of the hyd motor. Is this a flow control or?
Just not quite sure what I'm missing. Thanks.
Help with Spra-Coupe 7650 and Envizio Pro
I also can't get more than about 70 psi out of the pump. I've read the manual several times and can't find anything about adjusting this. I'm running 11002 nozzles and the flow control valve is working fine.
-Doesn't seem to matter if the sparge valve is open or closed.
-The bypass valve is also closed.
-The strainers are clean.
I see there is a set screw on top of the hyd motor. Is this a flow control or?
Just not quite sure what I'm missing. Thanks.
0 commentaires:
Enregistrer un commentaire